MiFare Classic (13.56MHz RFID/NFC) Sticker - 1KB Image

MiFare Classic (13.56MHz RFID/NFC) Sticker - 1KB

Adafruit

ADA-362
  • €2,50
Verot sisältyvät hintaan Toimituskulut lisätään kassalla.

Vain 19 jäljellä!

This is a blank MiFare Classic sticker - often used for inventory, identification but also found in other systems where a flexible, thin tag is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with the Adafruit PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.


Suosittelemme myös