Plastic Water Solenoid Valve - 12V - 1/2" Nominal

Adafruit

ADA-997
  • €8,00
Verot sisältyvät hintaan Toimituskulut lisätään kassalla.

Vain 0 jäljellä!
Saamme lisää jälkeen

‌Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2" (Nominal non-taped National Pipe) outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can push through. The valve has a gasket arrangement inside, so there is a minimum pressure requirement of 0.02 Mpa (3 PSI). Also, liquid can only flow one direction.

We tried this solenoid at various DC voltages and found we could actuate it down at 6VDC (although it was a little slower to open). Here is the current draw table for various voltages. We suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin.

Voltage/Current:

  • 6V 160 mA
  • 7V 190 mA
  • 8V 220 mA
  • 9V 240 mA
  • 10V 270 mA
  • 11V 300 mA
  • 12V 320 mA

If you want a beefier water valve, we also carry a brass version which does not have a minimum pressure requirement and can be used with liquid flow in either direction. 

These solenoids are not rated for food safety or use with anything but water.


Suosittelemme myös